Setup Incenter Cloud Version for Clavister Netwall UTM Firewalls

• Frist of all we should create a Pre-sharedkey include the information you can see on incenter cloud on my clavister.com from this way :
• Objects>general>keyring>Pre-sharedkey>add

​

• Give a custom name
• On Type choosing Hexadecimal key
• On passpharse paste the information from incenter cloud

• After this we should add a ipv4 address and a FQDN adress . one of theme is remote network of incenter cloud And one of theme is FQDN of incenter cloud remote endpoint

​

• IPV4 Address of remote network 

​

• FQDN Address of remote endpoint (you can find FQDN on you myclavister.com)

​

• after this we should create a LAN to LAN vpn over IPsec Tunnel for access to incenter network and connect device to incenter-cloud

​

        on vpn config page 

• Give a custom name 
• Remote end point is other side of vpn we prepare before as FQDN address 
• Local Network is your lan network single ip its mean the ip address of Lan 
• Remote Network is that ip we created frist of all and you can find on myclavister.com
• on Authentication Method we should using Pre-sharedkey we created before 

​

• after that we can check situation of IPsec tunel frome this way ​

​     status>subsystems>IPsec

• syslog reciver  

  we should add incenter cloud as log reciver also frome this way :   system>Logs and alerts>log Reciver

• give a name
• IP address should be ip address of remote network its mean incenter ip 
• port should be on 514 
• on Advance side should be choose InCenter Compatibility Mode

• Add device on incenter Cloud From manage side and Nodes 

​

• important issue name node of inceneter should be same as device name 

​